Last week I ordered 2x ubiquiti nanobridge m5 25dBi wireless devices in an attempt to bridge the networks of two local houses. I’m not usually one for reading instructions but found it slightly odd that I didn’t really know where to start with regard to mounting/aligning the dishes.

I managed to find which allowed me to read a bearing between the two premises:

Fortunately one of the houses already had a pole mounted on the roof with an old terrestrial tv aerial on. I started by taking this down and fitting one of the nanobridges to the existing pole and remounting it (roughly at a 20° bearing angled a few degrees down). This wasn’t fun being at the top of a ladder 20ft or so up!

I then found which allows you to enter the details of the wireless device types and locations providing feedback on expected signal etc (I found the website only worked in Safari, not in Chrome).

The first mistake I realise I made was not plugging in and testing the m5 before mounting it! I panicked a little after plugging it in and not seeing any new DHCP leases on my router! Fortunately I found out the m5 has a static ip address I changed my ip so I was on the same subnet and managed to access the webui.

I have yet to mount the nanostation at the other end, and expect things NOT to be straight forward as there’s not really line of sight or an existing convenient pole to mount the dish but fingers crossed I’ll get it working eventually!

I will post pictures of the installation and more information once I get the other end up.